Most cedar fences in Dallas don't fail in the pickets. They fail at the posts, right where the post meets the clay. This guide compares galvanized steel and pressure-treated wood posts on rot, termites, clay, corrosion, wall thickness, depth, wind and cost, with every number sourced. For how we build fences, see cedar fence installation in Dallas.
Steel vs wood fence posts in Texas clay soil, heat and humidity: the short answer
Galvanized steel posts sidestep rot and termites, two common reasons wood posts get replaced (Fixr fence repair, 2025). Either type still leans if it's set too shallow. Fixr says metal posts are unlikely to rot, can withstand strong winds and that termites are no match for them (Fixr, 2025). Texas A&M says wherever wood touches soil there is a high risk of termite entry (Texas A&M Urban Entomology).
| Question | Galvanized steel post | Pressure-treated wood post |
|---|---|---|
| Rot at the soil line | Unlikely to rot (Fixr, 2025) | Rot is common at post bases from constant soil contact (Fixr fence repair, 2025) |
| Termites | "No match" for metal posts (Fixr, 2025) | High risk wherever wood touches soil (Texas A&M) |
| Wind | Can withstand strong winds (Fixr, 2025) | Wood fencing may break, especially with 4x4 posts (Trex Fencing, 2021) |
| Published lifespan claims | 15+ years for a properly set post in Fort Worth clay (Top Rail Fence, 2026, contractor estimate) | Rotten posts can need replacing in 10 to 15 years (Trex Fencing, 2021) |
| Installed cost per post | $10 to $60 (Fixr, 2025) | $10 to $50 (Fixr, 2025) |
Why Dallas expansive clay pushes fence posts out of plumb
Blackland Prairie clay swells when wet and shrinks when dry, and that cycle works shallow posts loose every season. The USDA soil sheet for Houston Black clay says it covers about 1.5 million acres of the Blackland Prairie, which runs from north of Dallas to San Antonio, and shrinks and swells markedly with moisture (USDA NRCS, via Texas Water Development Board). For the soil science, see why Dallas clay moves.
A Fort Worth fence contractor says shallow posts "lean first" and "sink first" and pull the panels with them. It also warns that in clay, concrete "can actually backfire" when done wrong: swelling soil can push the collar up, and shrinkage opens a gap at the base where water collects and rot starts (Top Rail Fence, 2026).
Wood fence posts in Texas: rot and termites at the soil line
Wood posts fail where they meet the ground, so a wood post needs ground-contact treatment (Use Category 4A or higher), not the above-ground lumber used for pickets. The American Wood Protection Association says ground-contact posts need UC4A or higher and pickets UC3B or higher, and the category is printed on the end tag or stamp (AWPA, 2021).
Untreated wood doesn't last in the South. In a USDA Forest Service test at a high decay and termite hazard site in southern Mississippi, untreated southern pine fence posts lasted 2 years (Freeman et al., USDA Forest Service, 2005). The treated posts in that test used industrial preservatives, not home-store lumber, so their results don't apply to a store-bought post.
Concrete only helps so much. Trex Fencing says rain and sprinkler water eventually reach the bottom of a wood post, and rotten posts can need replacing in 10 to 15 years (Trex Fencing, 2021). More on termites and wood in Texas.
Steel fence posts vs pressure treated wood posts in Texas expansive clay soil: cedar privacy fence longevity, installation and corrosion
Published lifespans favor steel, but no source gives a clean head-to-head number, so compare the failure points instead.
- Steel: a properly installed steel post in Fort Worth clay should last 15 years or more (Top Rail Fence, 2026). That is a contractor's estimate with no wood figure beside it.
- Wood fences overall: 8 to 20 years at most (Fixr, 2025), 15 to 20 years for a well-built wood fence and 15 to 30 for cedar (Ergeon).
- Installation: the common wood setup is a 4x4 pressure-treated pine post every 8 ft, set 2 to 4 ft deep in cement (Ergeon wood fence page). Ergeon calls wood pickets on steel posts "a practical hybrid for windy sites and longer runs."
- Corrosion: steel's weak spot is the same as wood's, the soil line. See the rust section below.
Master Halco publishes a limited warranty for its PostMaster post, but its published documents give different terms, so check the current terms before counting on it.
PostMaster vs 2 3/8-inch round galvanized pipe vs square tubing: types of steel posts for wood fences
PostMaster is a flat channel post the fence boards hide, and 2 3/8-inch round pipe is the common DFW wood-on-steel post. Square tubing exists, but we found no spec data for it.
- PostMaster: a 3 1/2 by 1 3/4 inch channel of 11 gauge (0.120 inch) galvanized steel with a G90 zinc coating and pre-punched flanges (Master Halco spec). On the PostMaster Plus version, cover pickets conceal the posts (Master Halco install guide). Master Halco is based in Dallas.
- Round pipe: a DFW fence supplier with a Garland yard says wood-on-steel fences are typically built with 2 3/8-inch outside diameter pipe, which it stocks in .065, .080, .095 and schedule 40 wall (Viking Fence).
- Square tubing: the same supplier stocks it with a 5-day lead time (Viking Fence). We found no published gauge or strength data, so we don't compare it.
Steel post wall thickness: 0.065 vs 0.095 inch (16 vs 13 gauge)
On a 2 3/8-inch round post, 0.095-inch (13 gauge) wall is the heavier choice: 2.31 lb per foot against 1.60 lb for 0.065-inch (16 gauge), about 44% more steel (our arithmetic on Wheatland Tube's table). Wheatland Tube and a Texas supplier both list 0.095-inch pipe as 13 gauge (Wheatland Tube; American Fence & Supply).
| 2 3/8-inch pipe grade | Wall | Gauge | Weight per foot |
|---|---|---|---|
| Residential | 0.065 inch | 16 | 1.60 lb |
| WT-20 | 0.095 inch | 13 | 2.31 lb |
| WT-40 | 0.130 inch | 10 | 3.12 lb |
Source: Wheatland Tube fence framework tables. Viking Fence calls .065 common for residential and .080 to .095 heavier residential or light commercial. Ask any builder to write the post's diameter and wall thickness on the quote.
How deep to set fence posts in Dallas clay, and how far apart
Published guidance runs from 24 inches to 36 inches or more for a 6 ft fence, with gate and corner posts deeper, and spacing of 8 ft for a 6 ft fence. No source gives one official Dallas depth.
| Source | Depth guidance |
|---|---|
| This Old House | One-third of the post's height, plus 6 inches for gravel |
| Top Rail Fence, Fort Worth (2026) | At least 2 ft for a 6 ft fence, deeper in clay |
| PostMaster Plus install guide | Line posts 24 inches, corner and gate posts 30 inches |
| PostMaster spec (Master Halco) | 36 inches in firm soil, deeper in soft or loose soil |
| Top Rail Fence North Dallas (2026) | Its own standard: steel posts 36 inches deep in concrete |
Spacing depends on height and style. Master Halco allows up to 8 ft between posts on a 6 ft vertical fence and 4 ft on an 8 ft fence, and 4 ft on a horizontal fence of any height (Master Halco spec). A horizontal cedar fence needs more posts.
Gate posts carry the most load. This Old House says posts that support a gate need a concrete footing, and steel-framed gates are an option on wood-on-steel fences (Top Rail Fence project page). For bigger openings, see driveway and automated gates.
Wind: a 6 ft cedar privacy fence acts like a sail
A solid fence catches the full wind, and DFW storms have measured gusts above the design rating published for PostMaster, a steel post made for wood fences. Trex Fencing says privacy fences tend to act as a sail and may be damaged by strong winds (Trex Fencing, 2021).
Master Halco rates PostMaster to a minimum 73 mph (ultimate) wind load for a 6 ft solid fence with posts every 8 ft (Master Halco spec). On May 28, 2024, DFW Airport reported a 77 mph gust and Dallas Love Field 75 mph (FOX Weather, 2024). A rating and a gust aren't the same kind of number, so this doesn't mean a fence fails at 77 mph, but North Texas storms reach that range. See board-on-board vs side-by-side for how the solid styles compare.
Do galvanized steel fence posts rust in concrete or soil?
Galvanized posts are most at risk at the soil line, where water can pool, so the fix is concrete that sheds water away from the post. The Galvanizers Association of Australia says water pooling where galvanized steel meets soil can form a localized corrosion cell, and suggests extra protection for about 10 inches above and below the surface (Galvanizers Association of Australia).
The American Galvanizers Association says service life in soil depends on chlorides, moisture and pH (American Galvanizers Association, 2015). We found no published figure for how long the coating lasts in DFW soil. Master Halco says to slope or mound the concrete away from the post (Master Halco spec and install guide).
Dallas TX cedar fence steel post vs pressure treated wood post: material cost per post and installation (2026)
Published installed prices put a metal post at $10 to $60 and a wood post at $10 to $50 (Fixr, 2025). A wood fence in Dallas runs about $38 to $48 a foot installed (Ergeon Dallas page).
| Item | Price | Source |
|---|---|---|
| Wood post, material / installed | $5 to $20 / $10 to $50 | Fixr, 2025 |
| Metal post, material / installed | $5 to $30 / $10 to $60 | Fixr, 2025 |
| 2 3/8-inch x 8 ft galvanized post, 0.095-inch wall | $29.67 each | American Fence & Supply, read November 2026 |
| Installing privacy fence posts | $40 to $150 each | Fixr privacy fence guide, 2025 |
| Wood fence in Dallas, installed | $38 to $48 per foot | Ergeon Dallas page, read November 2026 |
| Replacing one failed post | $200 to $500 | Fixr fence repair guide, 2025 |
No reliable source we could open publishes a Dallas premium for steel posts over wood. Ergeon says wood-and-metal hybrid fences cost more than standard privacy fences but gives no figure (Ergeon, July 2026). For full fence totals, see what a cedar fence costs in Dallas per foot. Archetex gives a written price after a free site visit.
Dallas fence permits and height: why an 8 ft fence changes the post plan
Dallas requires a permit for a back-yard fence over 6 ft and caps fences at 9 ft. On PostMaster, an 8 ft solid fence needs posts every 4 ft instead of 8 (City of Dallas; Master Halco spec). On a 96 ft run, that is 25 posts instead of 13 (our arithmetic). See Dallas fence permits and who pays for a shared fence.
Dallas TX fence company for cedar fence steel posts: reviews, installation and what to ask
Archetex Outdoor Design Co. is a Dallas-based design and build company that builds cedar fences on galvanized steel posts. It is owned by Matthew and rated 5.0 on Google from 17 reviews. Each fence is laid out to the property's real lines and grade, with corners, gates and slopes handled rather than forced into a standard panel.
Whoever you hire, ask for these on the written quote:
- Post type, diameter and wall thickness (0.065 or 0.095 inch).
- Depth for line, gate and corner posts.
- Post spacing for your height and style.
- Concrete sloped or mounded away from the post.
- A UC4A or higher tag on any wood in the ground.
- Who pulls the permit.
Archetex serves Dallas, Plano, Frisco, McKinney, Richardson, Garland and Rockwall. Ask for a free site visit and a written price.

